Openocd program hex file

Yes, west can flash hex files. If you use the help command below, West prints how to point to a hex file: Permanently reprogram a board's flash with a new binary. build.dir-fmt configuration variable is set. The current directory is. checked after that. If. I am trying to use the program command in openocd-0.7.0 which seems simple enough to use. I have programmed the board using ISP using a hex file and "FlashMagic" with no problems It seems the first section of memory interrupt vectors up to 0x3f is being programmed with some other information. Is there any reason why this would occur?.

Running OpenOCD with nRF52 target. OpenOCD typically runs as a program in one terminal, and you interact with it via telnet on port 4444 from a second terminal. One neat trick to avoid the additional telnet session is to add -c "telnet_port pipe" to your command line. This will pipe stdin into openocd instead of opening the telnet port. I'm new on OpenOCD, has anyone attempted to use Olimex OpenOCD to actually flash program hex file (from Kiel say) into ARM CORTEX M0 (generic). What do I need to setup script file to take each word of the hex file to performs mww (memory write word) within the MCU flash?, can anyone provide an example. I use python. I open for suggestion.

Running OpenOCD with nRF52 target. OpenOCD typically runs as a program in one terminal, and you interact with it via telnet on port 4444 from a second terminal. One neat trick to avoid the additional telnet session is to add -c "telnet_port pipe" to your command line. This will pipe stdin into openocd instead of opening the telnet port. C:\Program Files\openocd-2006re115\bin. You should see two files, openocd-ftd2xx.exe for use with USB connected pods based on the FTDI2232 chip such as the Olimex ARM-USB-OCD openocd-pp.exe for use with parallel-port connected pods such as the Wiggler. OpenOCD must be run with a configuration file to specify various target options.